Stick drift test

Check analog stick offsets while your hands are off the stick.

Direct browser observationProcessed locally

Preparing

Ready

Reads the controller locally without uploading data or triggering vibration. Stop or leave the tab to end and clear results; maximum 120 seconds.

Controller support has not been checked.

Select two different axes to view a stick; the browser has not reported a standard mapping.

Browser-reported mapping
—
Displayed axes
—
Displayed buttons
—
Raw X
—
Raw Y
—
Distance from centre
—
Analog position and trail
Analog position and trail

The deadzone circle is a visual reference; it changes neither input data nor controller settings.

Observe rest position

Select Measure rest position, then release the stick. Allow 1 second to settle, followed by 5 seconds of observations. Do not move the controller or touch the stick during this window.

No rest-position observation yet.

Mean X
—
Mean Y
—
Mean radius
—
RMS radius
—
Maximum radius
—
Observations outside reference deadzone
—%
Browser observation count
—
Observation time span
—s

Offsets depend on drivers and system deadzones. Results do not establish a hardware fault; a zero reading does not guarantee a perfect sensor.

Results do not measure USB Polling Rate or latency. After an interruption, select Start to retry.

How to use

Connect a controller, select Start and press a controller button so the browser detects it. Choose a controller and axis pair. Changing controller, axes or deadzone clears drift results. Sessions last up to 120 seconds; Stop or leaving the tab ends the test and clears results.

Methodology

Waits 1 second to settle, then observes the rest position for 5 seconds. Summarizes distance from the center; continuous data is required.